Idp Requirements And Documentation; Isg 2000 Upgrade; Idp Configuration Through Netscreen-Security Manager - Juniper ISG 2000 User Manual

ISG 2000 User's Guide

IDP Requirements and Documentation

ISG 2000 Upgrade

IDP Configuration through NetScreen-Security Manager

NOTE:
viii
IDP Requirements and Documentation
You can upgrade the ISG 2000 to support Intrusion Detection and Prevention (IDP)
and then use NetScreen-Security Manager to configure IDP on the device.
To run IDP on the ISG 2000, you must set up the device as follows:
Upgrade the OS loader to v.1.1.5 or later.
Load the following license keys and firmware:
Advanced license key
IDP license key
ScreenOS 5.0.0-IDP1
Install at least one security module.
To obtain the upgrade kit and security modules, contact your value added reseller
(VAR). For information about upgrading the ISG 2000 to support IDP, refer to the
ISG 2000 Field Upgrade Guide, which is included in the ISG 2000 upgrade kit.
To configure IDP on the ISG 2000, you must use NetScreen-Security Manager 2004
FP3r3 or later.
NetScreen-Security Manager 2004 FP3r3 can operate on Solaris 9, Red Hat Linux
9.0, and Red Hat Enterprise Linux 3.0 operating systems.
For information on configuring IDP on the ISG 2000 through NetScreen-Security
Manager, refer to the following documentation:
NetScreen-Security Manager 2004 FP3-IDPr1 Installer's Guide – Instructions on
installing NetScreen-Security Manager
ISG 2000 Getting Started with IDP Guide – General instructions to help you get
started configuring IDP with NetScreen-Security Manager
IDP Deployment Strategies – Advanced IDP implementation scenarios
NetScreen-Security Manager 2004 FP3-IDPr1 Administrator's Guide – Complete
reference guide for NetScreen-Security Manager
NetScreen-Security Manager Online Help – Step-by-step configuration details
complementing the information in the administrator's guide
The NetScreen-Security Manager documentation is available on the Juniper
Networks Web site: www.juniper.net/techpubs.