Table of Contents
Advertisement
Console Connection and Login
To begin configuring the ISG 2000, make a console connection between your
workstation and the ISG 2000 and run a vt100 terminal emulator program.
1. Connect the power cable to the ISG 2000 and turn on the power.
2. Connect the female end of the supplied DB-9 adapter to the serial port (or Com
3. Connect one end of the RJ-45 ethernet cable into the console port of the ISG
Figure 4: Console Connection
4. Start a serial terminal emulation session. Use the following settings:
5. Press the Enter key to see the login prompt.
6. At the login prompt, enter netscreen
7. At the password prompt, enter netscreen
The login (admin name) and password are both case-sensitive. To change the login
NOTE:
name and password, see "Admin Name and Password" on page 5.
port) of your workstation.
2000 and the other end of the cable to the DB-9 adapter.
PWR
ALARM
TEMP
STA TUS
HA
FAN
MOD1
MOD2
MOD3
FLASH
ISG 2000
Connect the Rj-45 ethernet
cable to the console port.
Baud Rate to 9600
Parity to No
Data Bits to 8
Stop Bit to 1
Flow Control to none
Rear of Workstation
Plug the DB-9 adapter into the serial port,
and then connect the ethernet cable to the adapter.
Console Connection and Login
Chapter 1: Configuring
3
Advertisement
Table of Contents
