Inserting Interface Modules - Juniper ISG 2000 User Manual

Inserting Interface Modules

To insert an interface module into a module bay, perform the following steps:
WARNING:
is off. Interface modules are not hot swappable.
1. Align the side edges of the interface module card with the grooves in the side
Figure 19: Aligning Interface Module with Positioning Grooves
Positioning Groove
2. Push the interface module completely into the bay.
WARNING:
care that the electromagnetic interference (EMI) fingers along the top edge of the
front wall of the interface modules do not catch on the lower edge of the modules
above them in bays 1 and 3.
When inserting or removing interface modules, be sure that the power
walls of the bay.
Align the side edges of the interface module card with
the positioning grooves and then slide it into position.
When inserting and removing interface modules in bays 2 and 4, take
Chapter 3: Hardware and Servicing
Replacing Interface Modules
35