Rear-And-Front Mount - Juniper ISG 2000 User Manual

Rear-and-Front Mount

To mount the ISG 2000 with support from the rear and front, use the rear slide
mount kit.
1. Screw the left and right brackets to the front of each side of the
2. Screw the rear mount sleeves to the left and right rear posts of the rack.
3. With the indented groove that runs the length of each slide facing outward,
Depending on the depth of your equipment rack, you can attach the slides along
NOTE:
the length of the sides or extend them over the rear of the chassis.
4. Slip the slides into the rear mount sleeves.
5. Push the ISG 2000 forward until the left and right brackets contact the front
6. Screw the front left and right brackets to the front posts of the rack.
Figure 13: Rear-and-Front Mounted ISG 2000
ISG 2000 chassis.
screw the slides to the middle of each side of the ISG 2000 chassis.
rack posts.
PWR ALARM
FAN MOD1
TEMP STA TUS HA
ISG 2000
MOD2 MOD3 FLASH
Chapter 2: Installing
Equipment Rack Mounting
27