Power; Connectors; Front Controls, Leds, And Cd Drive - Nortel 2000 Hardware Installation Manual

Chapter 1 Application Gateway Overview

Power

Power

Connectors

Front Controls, LEDs, and CD Drive

2 Application Gateway Hardware Installation Guide
The power cord connector is located on the left side on the back of the
Application Gateway. When the power LED, on the front panel, is
illuminated, the power is on.The power control button is on the front
panel. The power supplies are factory installed and not customer
replaceable.
Attention: This server is suitable for use on an IT power distribution
system, whose maximum phase to phase voltage is 240 V under any
distribution fault condition.
The following topics describe the Application Gateway connectors:
Front Controls, LEDs, and CD Drive, page 2
•
Back Connectors, page 4
•
Figure 1 shows the front of the Application Gateway.
Figure 1 Application Gateway Front Controls, LEDs, and CD Drive