56/64K Csu/Dsu Wan Interface Card; Figure 36 56/64K Csu/Dsu Wan Interface Card - Nortel 1750 Install Manual

88 Appendix A Technical specifications

56/64K CSU/DSU WAN interface card

The 56/64K CSU/DSU WAN interface card has a single RJ-48 connector that
provides the signals needed to interface to network equipment.
Figure 36

Figure 36 56/64K CSU/DSU WAN interface card

The connector on the 56/64K CSU/DSU WAN interface card accommodates an
8-pin RJ-48 modular patch cord.
Use cable that is wired in accordance with ANSI T1.410 wiring style. This wiring
style ensures that a twisted pair inside the patch cord carries the transmit signal
(pins 1 and 2) and the receive signal (pins 7 and 8). Nortel strongly recommends
that you use professionally manufactured patch cords.
You connect the 56/64K CSU/DSU WAN interface card to the service provider
network using a straight-through cable or a crossover cable, depending on how the
service provider wired its jack.
NN46110-316 02.01
shows the 56/64K CSU/DSU WAN interface card.
56/64K
Note: Nortel does not supply an interface cable with the
56/64K CSU/DSU WAN interface card.
DDS