Figure 24 Installing and removing an option card
Option card
Motherboard
7
Lower the new option card into the slot, and gently press the connector into
the slot.
Seat the card in the slot. If you do not properly seat the card, it does not work.
8
Replace the screw that secures the card to the slot
9
Replace the top cover on the chassis
a
Hold the cover at an angle, and slide it onto the chassis.
b Use a screwdriver to insert and tighten the four screws that secure the
cover to the chassis.
10 If the VPN Router 1750 is installed in an equipment rack, mount it in the rack.
a
Set the VPN Router 1750 on the rack-mount shelf in the rack.
Chapter 3 Installing option cards and DIMMs 61
Rear of unit
Option card slots
(Figure 21 on page
Nortel VPN Router Installation — VPN Router 1750
Filler panel screw
CS2600017A
(Figure 24 on page
55).
61).