Sony HCD-C7NT Service Manual page 18

HCD-C7NT
3-12. Spindle Motor Assy (M904)
1 clip arm spring (L)
3-13. Jack Board, HP Board, Rear Cover
Note for re-installation-1
When installing the rear cover,
be careful that the three harnesses
coming from
" 5 Connector (CN107)",
" 8 Connector (CN109)",
" 9 Connector (CN110)",
and the harness coming from the
DC fan (M901) must not contact the
heat sink (IC902) and the diode
(D981) and the heat sink (IC904).
18
3 open to direction of the arrow A
A
8 spindle motor assy
(M904)
1 screw
(+BVTT 3 x 5)
8 connector
2 four screws
(+BV 3 x 12)
3 three screws
(+BV 3 x 8)
POWER board
heat sink (IC902)
diode (D981)
2 clip arm spring
7 spindle motor
7 screw
(+PTPWH 3 x 8)
9 connector
(CN110)
(CN109)
qs two nuts
(N4)
Note for re-installation-2
When installing the rear cover, be careful that the three
harnesses coming from
" 5 Connector (CN107)",
" 8 Connector (CN109)",
" 9 Connector (CN110)",
and the harness coming from the D.C. fan (M901) must not
be pinched by the rear cover, the UCOM board, power
transformer (T900) and tuner pack.
4 two screws
(+P 1.7 x 2.2)
5 turn table
6 washer
0 HP board
qf rear cover
6 JACK board
5 connector
(CN107) 4 two screws
(+BV 3 x 8)
qa two screws
(+B 4 x 16)
qd D.C.fan
(M901)