Sony HCD-C7NT Service Manual page 17

3-11. Base Section
5 two screws
(+P2 x 5)
1 pick-up flexible
board
3 Remove the two hang-up
springs (R) as shown.
0 base section
( 0 Remove the base block while the
mechanism is in the Loading IN state.)
4 Remove solderings from
the damper pins.
2 Remove the two hang-up
springs (FZ) as shown.
6 Move the holder (L) in the
direction of the arrow A .
8 Slant the base block in the
A
B
direction of the arrow B
and remove the base
block from the main unit in
a manner that the lock pin
passes through the groove
of the holder (L) as shown.
9 Remove solderings.
HCD-C7NT
7 Remove the two damper
pins toward inside.
holder (L)
lock pin
17