Table of Contents
Advertisement
3-5. Front Bracket Section, Loading Motor Assy (M902)
5 Remove the two
hang-up springs (FZ).
A
6 screw
(+P 2 x 3)
3 three claws
Note during re-assembling
When re-assembling, align the positions as shown.
front backet section
8 Remove it in the direction of
the arrow A from the left side
when viewed from the rear of
the front bracket.
7 screw
(M 2 x 4)
qa Move down the gear mount
chassis section
qg loading motor assy (M902)
2 screw
(M 2 x 2.5)
1 fpc holder
4 Raise the
CONNECTOR board.
bracket in the direction of the
arrow B .
B
qs screw
(+P 2 x 3.0)
0 loading belt
qf Remove two solderings.
qd front backet section
HCD-C7NT
9 wire clamper
13
Advertisement
Table of Contents
