Nortel Meridian M3904 Installation Manual page 2

Table 1: RS-232C pin requirements
Pin
2
3
4
5
6
20
7
Installing the Personal
Directory PC Utility
Software
Opening the Personal
Directory PC Utility
Selecting the serial
port
Standard 2.00
Personal Directory PC Utility Reference Guide
Function
TX
RX
RTS
CTS
DSR
DTR
GND
1. Close all applications.
2. Ensure that the Personal Directory PC Utility Cartridge is properly installed in the
ACM. See the installation guide that came with the cartridge for detailed
instructions.
3. Insert the Personal Directory PC Utility disk into the CD-ROM drive.
4. Click Start.
5. Select Run.
6. Enter D:\SETUP (assuming that drive D is the CD-ROM drive).
7. Click OK. The Nortel logo screen appears while the installation utility loads, then
the Welcome screen appears.
8. Click Next.
9. If you agree to the terms of the Software License Agreement, click Yes.
10. Continue to click Next until the installation is complete.
11. When prompted, remove the disk from the CD-ROM drive.
12. Click Finish.
13. Restart your PC.
1. Click Start.
2. Select Programs.
3. Select either the default folder, C:\Program Files\Nortel Networks\Personal
Directory PC Utility, or the folder where you installed the software.
4. Select PC Utility.
1. Click Phone in the Main Menu bar.
2. Click Set port. The pull-down menu shows all available serial ports.
3. Click the desired serial port.
Note: The program automatically selects the same port each time, unless that port is
now being used by another application such as a Palm Pilot.
Description
Transmit
Receive
Request to Send
Clear to Send
Data Set Ready
Data Terminal Ready
Ground Signal
Page 2 of 6 N0023528