Technical Description Of The Burner; Technical Data; Burner Description - Riello F10 INCINERATOR TL Installation, Use And Maintenance Instructions

4

Technical description of the burner

4.1

Technical data

Model
Thermal power
Output
Fuel
Electrical supply
Motor
Capacitor
Ignition transformer
Pump (Maximum pressure)
Absorbed electrical power
Protection level (EN 60529)
The burners are factory set to operate with continuous ventilation.
For standard burner operation, it is necessary to disconnect the plug (X9) of the relay assembly and connect the plug
(X9*) coming from the terminal board assembly at the plug (XP9) of the control box see "Electrical connections".
WARNING
4.2

Burner description

9
8
10
4
20098698
1 Pump
2 Control box
3 Gauge connection
4 Pump pressure regulator
5 Vacuum gauge connection
6 Screws fixing air damper
7 Air damper
8 Lock-out lamp and reset button
9 Photoresistor
10 Relay
11 Motor capacitor
20098581
Technical description of the burner
54 - 107 kW
4.5 - 9 kg/h
Gas oil, max. viscosity at 20 °C: 6 mm
Kerosene, viscosity 1.6 – 6 mm
Blends of gas oil and bio fuel (FAME in accordance with EN 14214) up to 30%
~
Single phase,
50 Hz - Run current 0.75A
2850 rpm - 298 rad/s
60 Hz - Run current 0.75A
3340 rpm - 349 rad/s
7 - 15 bar
11 18
12 13
R40 F10
2
/s (1.5 °E - 6 cSt)
2
/s at 20 °C (Hi = 11.97 kWh/kg)
50/60 Hz 230 V ± 10%
5 F
Secondary 8 kV – 16 mA
0.20 kW
IP X0D
7
6
17
12 7 pole socket
13 4 pole socket
14 Transformer
15 Motor
16 Safety valve
17 Flange with insulating gasket
18 Combustion head
19 Combustion head adjustment screw
8 GB
R40 F20
95 - 202 kW
8 - 17 kg/h
50 Hz - Run current 1.4A
2850 rpm - 298 rad/s
60 Hz - Run current 1.3A
3340 rpm - 349 rad/s
14 bar
0.32 kW
IP X0D
19 14
16 1 3
Tab. A
2
5
15
Fig. 1