Mercedes-Benz EQE Operator's Manual page 209

Press and hold button 1, 2 or
#
wish to program.
Indicator lamp 4 will flash yellow.
%
It can take up to 20 seconds before the indi-
cator lamp flashes yellow.
Release the button previously pressed.
#
Indicator lamp 4 will continue to flash yellow.
Point remote control 5 from a distance of
#
0.4 in (1 cm) to 3 in (8 cm) towards button
1, 2 or 3.
Press and hold button 6 of remote control
#
5 until one of the following signals appears:
Indicator lamp 4 lights up green continu-
R
ously. Programming is complete.
Indicator lamp 4 flashes green. Program-
R
ming was successful. Additionally, the roll-
ing code must be synchronized with the
door system.
If indicator lamp 4 does not light up or flash
#
green: repeat the procedure.
Release all of the buttons.
#
3 that you % The remote control for the door drive is not
included in the scope of delivery of the garage
door opener.
▌Synchronizing the rolling code
Requirements
The door system uses a rolling code.
R
The vehicle must be within range of the garage
R
door or door drive.
The vehicle as well as persons and objects are
R
located outside the range of movement of the
door.
Press the programming button on the door
#
drive unit.
Initiate the next step within approximately
30 seconds.
Press previously programmed button 1,
#
or 3 repeatedly until the door closes.
When the door closes, programming is com-
pleted.
% Please also read the operating instructions for
the door drive.
Driving and parking 207
▌Troubleshooting when programming the remote
control
Check if the transmitter frequency of remote
#
control 5 is supported.
Replace the batteries in remote control 5.
#
Hold remote control 5
#
a distance of 0.4 in (1 cm) to 3 in (8 cm) front
of the inside rearview mirror. You should test
every position for at least 25 seconds before
trying another position.
Hold remote control 5
#
various distances in front of the inside rear-
view mirror. You should test every position for
at least 25 seconds before trying another
position.
On remote controls that transmit only for a
#
limited period, press button
2
control 5 again before transmission ends.
Angle the antenna line of the garage door
#
opener unit towards the remote control.
at various angles from
at the same angles at
6 on remote