Startup And Shutdown; Startup Of This Device - Konica Minolta AeroDR SYSTEM Operation Manual

3 .1

Startup and shutdown

Normally, this device is used with the power on.
When not used for more than 1 day, operate the start-
up/shutdown as follows.
HINT •••••••••••••••••••••••••••••••••••••
• There is no specific sequence which should be started
up first, this device or the image processing controller.
The startup and shutdown sequences of this device
are as follows.
• If the power synchronization function of the DR De-
tector is enabled and the wired cable is connected,
the startup / shutdown of the DR Detector will be per-
formed along with the startup / shutdown of the syn-
chronizing device.
• • •• • • •• • • •• •••••••••••••••••••••••••••••••••• •••••••
Reference •••••••••••••••••••••••••••••••••••••
• Refer to the "Operation Manual" of the image processing
controller regarding on/off for the image processing controller.
• • •• • • •• • • •• •••••••••••••••••••••••••••••••••• •••••••

3 .1 .1 Startup of this device

The startup methods of this device are as follows.
 AeroDR 1417HQ, AeroDR 1417S, Aero-
DR 1717HQ, AeroDR 1012HQ, AeroDR 2
1417HQ, AeroDR 2 1417S
• If the DR Detector is inserted into the AeroDR
Battery Charger or AeroDR Battery Charger2
with a wireless connection, the DR Detector
should be removed.
• For a wired connection, confirm that the wired
cable is connected securely to the wired con-
nection connector of the DR Detector.
• Next, press the power switch of the DR Detec-
tor for 2 seconds and turn it on, and confirm that
the LED (green) is slowly flashing or lit.
IMPORTANT •••••••••••••••••••••••••••••••••• • ••
• Do not use a sharp object to operate the switch; doing so
may damage the AeroDR 2 1417HQ and AeroDR 2 1417S.
•••••••••••••••••••••••••••••••••••••••••••••••••• • ••
 AeroDR 3 1417HD, AeroDR 3 1717HD,
AeroDR 3 1012HQ
• If the DR Detector is inserted into the AeroDR
Battery Charger2 with a wireless connection, the
DR Detector should be removed.
• For a wired connection, confirm that the wired
Cable is connected securely to the wired con-
nection connector of the DR Detector.
• Next, press the Power SW of the DR Detector
for 2 seconds to turn it on and confirm that the
Information LED (white) gradually extends while
the triangle part flashes and the rectangular part
below it lights and then goes out before the Bat-
tery LED lights.
Information LED (white)
Battery LED (blue/orange)
HINT •••••••••••••••••••••••••••••••••• • ••
• The Battery LED changes according to the level of
battery power of the DR Detector.
•••••••••••••••••••••••••••••••••••••••••••••••••• • ••
60
Power switch
LED (green)
Power SW