Installation Of The Tubes For The Ganimede N - Hach GANIMEDE P User Manual

Color in tube
Identification
plan
A: (included in
the scope of
delivery of the Black
sample
changer)
B Red
C Pink
D Gray
E Green
F Blue
G Green
H Orange
J Black
K Purple
L Black
3.1.4.2

Installation of the tubes for the Ganimede N

Table 1 Tube overview for analysis unit P
Dia-
Length
meter
400 mm 2.67 mm
140 mm 2.67 mm
380 mm 3.04 mm
300 mm 3.04 mm
530 mm 3.2 mm
450 mm 3.2 mm
300 mm 3.04 mm
180 mm 3.04 mm
550 mm 3.53 mm
500 mm 4.17 mm
300 mm 3.04 mm
1. Install all tubes of the analysis unit in accordance with
analysis unit N, page
2. Screw the large blue lid onto the empty waste bottle (1500 mL).
Note: The waste bottle can take the reagent and sample waste from 100 individual
determinations.
3. Connect the GCA 200 reagents with the corresponding lids of the same color.
4. Install sample tube A.
To do so, lead the free end of sample tube A out through the left-hand side of the
analysis unit housing.
Connect the upper end of the sample needle with sample tube A.
5. Insert the sample needle into the guide of the sample changer arm.
Note: The sample needle must not reach the bottom of the sample container when magnetic
rods are used.
Colored
adapter
Sample changer sample needle
- -> Left-hand side of the analysis unit housing
-> Valve 1 connection f
Valve 1 connection b
-
-> Left-hand analysis cuvette
Valve 1 connection g
Yellow/blue -> Pump 1
-> Digestion cuvette
Digestion solution A
-
-> Valve 1 connection d
Right-hand analysis cuvette
Yellow/blue -> Pump 2
-> Valve 2 connection g
Color solution B
-
-> Valve 2 connection e
Reduction solution C
-
-> Valve 2 connection c
Distilled water
-
-> Valve 2 connection b
Analysis cuvette
Gray/green/g
reen
-> Pump 3
Lower analysis cuvette
-> Pump 4
Gray/black/p
urple
-> T-piece -\> Valve 1 connection c
and -\> Waste bottle
Acid solution D
-
-> Valve 2 connection d
27.
Installation
Connected:
Figure 12 Tube plan for
25