ABB i-bus KNX Product Manual page 147

ABB i-bus® KNX PARAMETERS
—
7.9.4.1.1
DEPENDENT PARAMETER
Move to position
This parameter can be used to define how the blind/shutter moves to the target position.
More information → Direct and indirect movement to the position, Page 88
Options
Direct
Indirectly via upper end position The blind/shutter moves to the upper end position first, then to the target position.
Indirectly via lower end position
Indirectly via shortest way
Condition for visibility:
Parameter window Blind/Shutter \ Parameter Parameter setting \ Option Individual
—
7.9.4.1.2
DEPENDENT PARAMETER
Enable group objects "Move to pos. height/Move to pos. slat"
This parameter can be used to enable the group objects Move to position height and Move to position
slat .
The group object Move to position slat is available only in the Operating mode Blind/shutter control
with slat adjustment .
Options
No
Yes
Condition for visibility:
Parameter window Blind/Shutter \ Parameter Parameter setting \ Option Individual
The target position is approached directly.
The blind/shutter moves to the lower end position first, then to the target position.
The blind/shutter moves to the closer end position, then to the target position.
Note
The group objects will not be enabled.
The group objects will be enabled.
Product manual | SAH/S x.x.7.1 | 2CDC505173D0211 Rev. A 147