ABB i-bus KNX Product Manual page 145

ABB i-bus® KNX PARAMETERS
7.9.4 Parameter window Blind/Shutter
The following settings can be made in the Parameter window Blind/Shutter:
• Move to position
• Enable group objects "Move to pos. height/Move to pos. slat"
• Determine slat adjustment time
• Setting travel range limit
• Set dead times
More information → Blind/slat settings, Page 88.
If several Shutter Actuator output pairs are to be set to the same values, parameterization can be per-
formed in Parameter window Shutter Actuator template.
Fig. 42: Parameter window Blind/Shutter
All functions, parameters and group objects in the following section that refer to slat settings are
available only in Operating mode Blind/shutter control with slat adjustment .
Note
Note
Product manual | SAH/S x.x.7.1 | 2CDC505173D0211 Rev. A 145