Siemens SION 3AE Series Operating Instructions Manual page 6

Transport/storage/packing
WARNING
Fig. 2 Unpacking the SION
grounding switch
Fig. 3 Unpacking the SION
grounding switch
4
Heavy Equipment
Can cause serious personal injury.
Use care when racking the breaker into the disconnect position. When a
draw-out circuit breaker is mounted tilting toward the front side, it is possible
that the circuit breaker may slide out on the rails.
®
The SION withdrawable module with vacuum circuit breaker and grounding
switch can tilt over after removal from the packing and must be supported.
®
withdrawable module with
®
withdrawable module with
·
Open the packing from above
·
Remove cover board secured with clips in the
upward direction
·
Remove cross struts secured with clips
·
Remove side walls secured with clips
·
Cut through the adhesive tape holding the foil
covering in place and carefully remove the foil
·
Undo the wood screws, as shown in Fig. 3
·
Undo the hexagon screws (10 mm) from the
brackets, as shown in Fig. 3, and remove the
brackets
·
Use suitable hoisting gear to lift the SION
withdrawable module with grounding switch
out of the packing.
®
9229 0002 401 0A
2016-03-03