Step 2. Assembly - North Star M1571493E Owner's Manual

Step 2. Assembly

Note: Remove all contents from pallet and assembly can
occur at this time.
1. Install wheel onto axle using a 5/32" allen
wrench. Repeat on other side.
2. Install nozzles into Grommets, install Grommets
onto frame and install rubber feet.
FIG06858
INSTALL RUBBER FEET WITH
5/16" X 1" BOLTS + 5/16" NUTS
Initial Set-up
INSERT GROMMETS INTO
FRAME AND INSERT
NOZZELS INTO GROMMETS
12
3. Install grip onto handle.
4. Attach small bumper to handle with ¼" x ¾" self-
tapper.
5. Insert (1) 3/8" x 2-1/2" bolt through (1) flat
washer and through one end of lanyard as
shown below. Attach 3/8" cotterless pin to other
end of lanyard.
6. Install handle to pressure washer using 3/8" x
2-1/2" bolt, (4) flat washers and (1) 3/8" nyloc
nut until washers press against tube walls.
Repeat for both sides.
7. Insert cotterless pin through bottom hole of arm
so handle doesn't fold up while in use.
WARNING: High Pressure Fluid Injection
Hazard
High-pressure fluid discharge from leaks (even pin-
sized) or ruptured components can pierce skin and
inject fluid into the body. Injection injury can result in
blood poisoning and/or severe tissue damage leading
to infection, gangrene, and possibly amputation.
•
Never use a finger or skin to check for
leaks.
•
Never operate machine with damaged or
missing hoses/parts.
•
Never attempt to repair a high-pressure
hose or component – Always replace it with
a part that is rated at or above the pressure
rating of this machine.