Inspect Fuel System/Check For Leaks - North Star M1571493E Owner's Manual

Always follow these general safety rules when
fueling:
1) Turn pressure washer off and allow to cool for at least
two minutes before removing the fuel cap.
Note: A running or still-hot engine is hot enough to
ignite fuel.
2) Fill fuel tank OUTDOORS – never indoors. Fuel
vapors can ignite if they collect inside and enclosure
and explosion can result.
3) Stay away from all sources of heat, sparks, and
flames. Do not smoke.
4) Never pump fuel directly into the gas tank at a gas
station – it could cause a static electric spark. Follow
these steps to avoid static electric sparking during
fueling:
•
Use an approved portable container to transfer
fuel to the pressure washer's tank. (A portable
container made of metal or conductive plastic is
preferred because it dissipates charge to ground
more readily.)
•
Always place container on the ground to be filled.
Never fill the portable gas container while it is
sitting inside a vehicle, trailer, trunk, or pick-up
truck bed.
•
Dissipate static charge from your body before
beginning the fueling process by touching a
grounded metal object at a safe distance from
fuel sources.
•
Keep nozzle in contact with container while filling.
Do not use a nozzle lock-open device.
5) Clean up fuel spills/splashes immediately.
•
If possible, move the pressure washer away from
spilled fuel on the ground.
•
Wipe up spilled fuel and wait 5 minutes for
excess fuel to evaporate before starting engine.
•
Fuel soaked rags are flammable and should be
disposed of properly.
•
If fuel is spilled on your skin or clothes, change
clothes and wash skin immediately.
Fill Engine Fuel Tank
Check the gasoline tank level. If needed, fill tank with
fresh unleaded gasoline from a portable container:
1) Remove engine gas cap.
2) Add gasoline through the fill opening:
- Use only a UL-listed portable gasoline container to
transfer the gasoline to engine's tank.
Operation
- Do NOT overfill the gasoline tank. Allow at least
1/2" of empty space below the fill neck to allow for
fuel expansion.
3) Replace gas cap securely before starting engine.
4) Store extra gasoline in a cool, dry place in an UL-
approved, tightly sealed container.

Inspect Fuel System/Check for Leaks

Inspect the engine fuel system and check for leaks before
starting pressure washer and before each use.
Do not start pressure washer until all needed repairs
have been completed.
WARNING: Fuel Leak Hazard
Gasoline fuel is highly explosive and fuel
leaks can result in fire or explosions. You
can be burned and seriously injured if the
fuel system is not properly hooked up or
there is a fuel leak when you start the
engine.
Inspect the entire fuel system. Look for:
•
signs of leaks or deterioration
•
chafed or spongy fuel hose
•
loose connections
•
loose or missing fuel hose clamps
•
damaged fuel tank
•
defective gasoline shut-off valve
Inspect Spray System
Always inspect spray system for damage and leaks
before each use. Do not start pressure washer until all
needed repairs have been completed.
18