Caller Id; Source Id - ADTRAN ATLAS User Manual

C ID
ALLER
S ID
OURCE
61200263L1-1.1
DLCI
Write Security: 3; Read Security: 5
Selects the appropriate DLCI for this dial plan entry.
V P
OICE ORT
Write Security: 3; Read Security: 5
Identifies the voice port address of the remote unit. FSU 5622s support
ports 1 and 2. A remote ATLAS supports ports 1 through 255.
C R
ONFLICT EPORT
Read Security: 5
Provides a description of a conflict if it exists. Potential problems include
DLCI unavailable or Voice port already in use.
V C
OICE OMPRESSION
Write Security: 3; Read Security: 5
Selects the voice compression algorithm used by this endpoint. Older
ADTRAN 5622 FRADs use CCITT G.723.1 compression at 6.3 kbps. Newer
FRADs also support the proprietary NETCODER algorithm at 6.4 kbps.
Both endpoints must agree about the compression algorithm choice.
S S
ILENCE UPPRESSION
Write Security: 3; Read Security: 5
Reduces the total system bandwidth load by preventing ATLAS from send-
ing frames containing a special silence code during periods of silence. Both
endpoints must agree to use silence suppression. By default, silence sup-
pression is D . To prohibit silence frames from transmitting and to
ISABLED
decrease the total system bandwidth, E
S M
IGNALING ETHOD
Write Security: 3; Read Security: 5
Selects the type of signaling that the remote port is configured to expect.
Available options include the following: E&M I
L S .
OOP TART
D I D
IRECT NWARD IALING
Write Security: 3; Read Security: 5
Defines whether or not Direct Inward Dialing (DID) is used by the remote
equipment. If DID is enabled, then the following options must be config-
ured for N and U
ETWORK
Write Security: 3; Read Security: 5
Defines the number ATLAS uses to provide caller ID to the network for out-
going calls sent through this endpoint. This field only displays if D
I D is set to D
NWARD IALING
menu item is optional.
Write Security: 3; Read Security: 5
Defines the source ID. This field only displays if D
set to D , and U
ISABLED SER
optional.
ATLAS Frame Relay User Manual
Chapter 5. Connecting Packet Endpoints
this feature.
NABLE
MMEDIATE
T configurations.
SER ERM
, and U T
ISABLED SER ERM
is selected. Setting this menu item is
T
ERM
, E&M W , and
INK
IRECT
is selected. Setting this
I D is
IRECT NWARD IALING
5-7