Table of Contents
Advertisement
S
UBLINKS
Packet Endpnts
Packet Manager
Packet Cncts
Cncts Sort
Frame Relay IQ
a. Only available when the selection is Primary.
b. Only available when the selection is Backup.
c. Only available when the selection is Primary
with Backup Support or Backup.
61200263L1-1.1
Write Security: 3; Read Security: 5
Allows PVC creation and configuration within a frame relay link that uses sub-
link DLCIs (see Figure 4-11). Sublinks are not supported in TBOP or PPP.
Status
Endpnt Name
Performance
Protocol
Config
Config
Test
Sublinks
Endpnt Count
Usage
Endpnts Sort
N
AME
User-defined name for the DLCI.
DLCI
Local address for each PVC as assigned by the carrier.
QOS
Quality of service. These values can be used to assign a guaranteed amount
of bandwidth available for this connection. The sum of all QOS values for
the sublink should not exceed the Committed Information Rate (CIR).
C
ONFIG
Allows configuration of parameters for each DLCI.
I
-B
S
N
AND
EQUENCE
This option will not appear when D
T
D
HROUGH
IAGNOSTIC
bered tag so that ADTRAN IQ products can detect lost packets in the
frame relay network. Only turn this option ON if there is an ADTRAN
IQ-capable product on the other end of the PVC.
ATLAS Frame Relay User Manual
Chapter 4. Defining Packet Endpoints
In-band Sequence Number
Remote FECN Notification
React to BECN
Drop DE Packets when overloaded
Fragmentation Threshold
Fragmentation Size
DLCI State
Diagnostic Mode
Primary | Backup Selection
Enable Backup Support
Name
Backup Packet Endpt
DLCI
Backup Sublink
QOS
Primary Packet Endpt
Config
Primary Sublink
Backup Mode
Switch on Sublink Down
Switch on LMI Inactive
Switch on Backup Active
Backup Delay in Seconds
Restore Delay in Seconds
Figure 4-11. Sublinks Menu Tree
N
UMBER
IAGNOSTIC
. All packets on this PVC will get a num-
P
ACKETS
a
a
a
b
b
c
M
is set to P
ODE
ASS
4-15
Advertisement
Table of Contents
