Table of Contents
Advertisement
Speaker On... field. Supported options are:
Selection:
Never
Until Carrier
During Answer
Always
When the modem speaker is on, you can adjust the volume in the Speaker Volume... field.
Press Escape twice to return to the WAN Configuration screen, and select Backup Configuration
(shown on
page
9-6).
If you select (Wan Module 2) Setup... and have an ISDN card in slot 2, the following screen appears:
Switch Type...
Directory Number 1:
SPID 1:
Directory Number 2:
SPID 2:
PBX Prefix:
Enter information supplied to you by your ISDN phone company.
The router will attempt to auto-detect all of your ISDN parameters. If it cannot do so, you can edit them
manually in the ISDN Line Configuration screen. You can select the Switch Type that your ISP or corporate
site uses from the pop-up menu. Enter your Directory Number(s) and SPID(s) as required, and a PBX
Prefix, such as "9" for an outside line, if you need one.
Press Escape twice to return to the WAN Configuration screen, and select Backup Configuration (shown on
page
9-6).
Turns off all speaker activity and hides the Speaker Volume control.
The default. Allows call placement and handshaking tones to be heard.
Same as above, but blocks dialing tones.
Allows carrier tones to be heard, as well.
ISDN Line Configuration
Behavior:
Auto-Detect
Dial Backup 9-5
Advertisement
Table of Contents
