Table of Contents
Advertisement
Setting up
Fastening the adapter cover
Use the supplied adapter cover to
prevent the USB wireless adapter from
coming off easily.
1.
Loosen the screw (marked with
triangle) on the bottom left of the
USB TYPE A port.
2.
Insert the tab of the cover into the
hole at the upper right of the USB
TYPE A port in the direction of the
arrow.
3.
Align the screw holes on the
projector and the cover. Then
insert the screw removed from the
projector into the hole and tighten
the screw.
WARNING
►Keep small parts away from children and pets. Take care not
to put in the mouth.
Using the security bar and slot
A commercially available anti-theft chain or
wire can be attached to the security bar on
the projector. Refer to the figure to choose
an anti-theft chain or wire.
Also this product has the security slot for
the Kensington lock.
For details, see the manual of the security
tool.
WARNING
►Do not use the security bar and slot to prevent the projector
from falling down, since it is not designed for it.
CAUTION
►Do not place anti-theft chain or wire near the exhaust vents.
It may become too hot.
NOTE
• The security bar and slot is not comprehensive theft prevention
measures. It is intended to be used as supplemental theft prevention measure.
http://www.pureglare.com.au
16
1
3
11.7mm
Anti-theft
chain or wire
2
Security slot
17.5mm
20.3mm
security bar
Tab
Advertisement
Table of Contents
