Table of Contents
Advertisement
Item
SERVICE
(continued)
(continued on next page)
http://www.pureglare.com.au
Selecting this item displays COMMUNICATION
menu.
In this menu, you can configure the serial
communication settings of the projector using the
CONTROL port.
• Select an item using the cursor buttons ▲/▼.
Then pressing the ► button opens the submenu
for the setting item you selected. Or, pressing
the ◄ button instead of the ► button makes the
menu back to the previous one without changing
the setup. Each submenu can be operated as
described above.
• When COMMUNICATION TYPE (below) is
set to OFF, the other items in COMMUNICATION
menu are invalid.
• For the function of serial communication, refer to
the Network Guide.
COMMUNICATION
COMMUNICATION TYPE
Select the communication type for transmission via
the CONTROL port.
NETWORK BRIDGE: Select this type, if it is
required to control an external device as a
network terminal, via this projector from the
computer. Select WIRELESS or WIRED as your
network connection mode.
The CONTROL port doesn't accept RS-232C
commands (6. Network Bridge Function in
the Network Guide)
OFF: Select this mode to receive RS-232C
commands using the CONTROL port.
• OFF is selected as the default setting.
• When you select the NETWORK BRIDGE, check
the item, TRANSMISSTION METHOD (60).
Description
NETWORK BRIDGE (WIRELESS)
NETWORK BRIDGE (WIRED)
OFF
OPTION menu
59
Advertisement
Table of Contents
