Jeep WRANGLER 2023 Manual page 29

NOTE:
If the charging schedule is not enabled, the

vehicle will charge whenever plugged in. It is not
necessary to set up the charging schedule to
charge the vehicle.
If "Charge Until Full" is selected, and the vehicle

is plugged in after the start time of the schedule,
the vehicle will start charging when it reaches
the start time the next day. If you would like to
begin charging immediately, and continue
charging until the vehicle is fully charged, you
must select the "Charge Now" option or use the
double plug override option.
If the vehicle is plugged in outside of the set

charging schedule (and "Charge Until Full" is not
selected), the vehicle's battery will not charge.
Charging will only begin immediately if the
vehicle is plugged in within the time and day of
the week set in the schedule or the schedule is
bypassed. Otherwise, charging will automati-
cally begin when the selected charge time and
day of the week occurs when plugged in.
SCHEDULE BYPASS
NOTE:
If the vehicle is turned off outside of the charging
window, a radio pop-up message will be displayed.
The pop-up message asks the driver if they would
like to "Charge Now?" and provides the next
charging schedule start time and estimated time to
charge the battery to 100%. If within one hour of
selecting "Yes", the vehicle is connected to a
powered EVSE, the vehicle will immediately begin
to charge (temporarily ignoring any set charge
schedule). To fully deactivate the charge schedule,
select the "Enable Schedule" checkbox until the
check mark is removed from the box.
The charging schedule can also be overridden if an
EVSE is plugged in, unplugged, and then plugged in
a second time to the vehicle. This double plug
sequence will override the set schedule in the
Hybrid Electric Pages App, and begin charging the
vehicle immediately. The double plug sequence
must be completed within 10 seconds for it to
override the programmed schedule.
GETTING TO KNOW YOUR VEHICLE
e-Save
The fourth screen within the Hybrid Electric Pages
App is the e-Save screen. From this screen, you can
specify the behavior of the e-Save drive mode:
Battery Save - Maintains the high voltage State

of Charge at its current level.
Battery Charge - Uses additional power from the

gas engine to increase the high voltage State of
Charge, up to 95% capacity.
NOTE:
For information on jump starting your vehicle, refer
to the "In Case Of Emergency" chapter in the
Owner's Manual.
IGNITION SWITCH
This feature allows the driver to operate the
ignition switch with the push of a button as long as
the key fob is in the passenger compartment.
27
2