Jeep WRANGLER 2023 Manual page 18

16 GETTING TO KNOW YOUR VEHICLE
Charging Schedule — Check whether the

charging schedules have been enabled. If
enabled, check that you are within the
scheduled time and day of the week. If a
charging schedule has been enabled in the
vehicle, and it is outside the time and day of
the week, you may override the schedule for
this charging event by plugging in the
charge connector, unplugging it, and then
plugging it back into the vehicle charge
inlet. Complete the double plug sequence
within 10 seconds for it to override the set
schedule.
Hood Ajar — Check whether the hood is

open. Charging is disabled while the hood is
open, and will resume when the hood
closes.
5. To stop the charging process, disconnect the
Portable Charging Cordset (EVSE) from the
vehicle first, and then from the wall outlet. To
disengage the vehicle coupler, push the button
on the connector.
Removing The Charge Connector From The
Vehicle Charge Inlet
6. Close the inlet door when a Portable Charging
Cordset (EVSE) is not connected to the vehicle.
NOTE:
It is good practice to keep the ignition in the OFF
position while conducting Level 1 charging. This
minimizes any additional vehicle loads the
Portable Charging Cordset (EVSE) has to support.
The additional electrical loads will extend the high
voltage battery charging time.
Troubleshooting Using The Status
Indicator Display
If the vehicle is not charging properly, consult the
status indicator lights.
The Green LED signals correct operation of the
system.
The Red LED signals a failure in the charging
system.
The Yellow LED signals a failure with the outlet.
LED Indicator Lights
1 — Green LED
2 — Red LED
3 — Yellow LED