Exmark QUEST S Series Operator's Manual page 64

Maintenance
Figure 75
1. Lift arm
2. Hairpin cotter
C. Remove the lift arm from the deck pin.
D. Repeat steps B and C for the other side
of the machine.
E. Slide the mower deck rearward to remove
the mower belt from the engine pulley.
• For 48 and 54 Inch Models
A. At the rear of the mower deck, remove the
two shoulder bolts and nuts securing the
deck to the pivot pan.
Figure 76
1. Nut
2. Pivot pan
g295768
3. Washer
g299079
3. Shoulder bolt
B. At all four corners of the deck, remove the
hairpin cotter and washer from the deck
pin
1. Deck pin
2. Hairpin cotter
C. Raise the height of cut to the highest
position.
D. Remove the belt from the clutch pulley on
the engine.
3. Slide the mower deck out from underneath the
machine.
Note: Retain all parts for future installation.
Installing the Mower Deck
Service Interval: As required
1. Park machine on level ground, disengage the blade
control switch, engage the parking brake, stop
engine, and remove key. Wait for all moving parts
to stop before leaving the operator's position.
2. Slide the mower deck under the machine.
64
Figure 77
3. Washer
g299015