Pushing The Machine By Hand - Exmark QUEST S Series Operator's Manual

2. Locate the tracking adjustment bolt near the
motion control lever on the side that needs
adjusting (Figure 23).
Note: Raise the seat for easier access to the
adjustment bolt.
3. Rotate the bolt to decrease the speed for the
wheel.
Note: Rotate the bolt a small amount to make
minor adjustments.
1. Bolt
4. Start the machine and drive forward across a flat,
level surface with the motion control levers fully
forward to check if the machine tracks straight.
Repeat the procedure as needed.
Pushing the Machine by
Hand
Important: Always push the machine by hand.
Never tow the machine because damage may
occur.
Figure 23
To Push the Machine
1. Park machine on level ground, disengage the blade
control switch, engage the parking brake, stop
engine, and remove key. Wait for all moving parts
to stop before leaving the operator's position.
2. Locate the bypass levers on the frame on both
sides of the engine.
3. Move the bypass levers forward through the key
hole and down to lock them in place as shown in
Figure 24. Ensure this is done for each lever.
4. Turn the ignition key "ON" but Do Not start the
engine. Release the parking brake.
• For E- and S-Series Models, move one control
lever inward to the neutral operate position.
• For X-Series Models, push the brake lever
forward and down.
The machine is now able to be pushed by hand.
g294926
1. Bypass lever location
2. Lever position for
operating the machine
5. When finished, ensure the key has been returned
to the "OFF" position to avoid draining the
battery charge.
35
Operation
Figure 24
3. Lever position for
pushing the machine
g333974