Operating The Blades - Exmark QUEST S Series Operator's Manual

period between attempts. Failure to follow
these instructions can burn out the starter
motor.
5. Once the engine starts, gradually move the choke
control rearward (if applicable) as the engine
warms. If the engine stalls or hesitates, slightly
move the control forward for a few seconds.

Operating the Blades

The blade control switch, represented by a power
take-off (PTO) symbol, engages and disengages
power to the mower blades. This switch controls
power to any attachments that draw power from the
engine, including the mower deck and cutting blades.
Engaging the Blades
1. Release the parking brake.
• For E- and S-Series Models, move the control
levers inward from the center T-slot positions.
• For X-Series Models, push the brake lever
forward and down.
2. Move the throttle midway between the "SLOW"
and "FAST" positions.
Note: Always engage the blades with the throttle
in the midway position.
3. Pull out on the blade control switch, to the "ON"
position, to engage the blades.
1. Throttle–Midway position 2. Blade control
4. Move throttle to full forward position before
mowing.
Figure 12
switch—ON position
Disengaging the Blades
Set the throttle to the midway position. Push the
blade control switch to "OFF" to disengage the
blades.
Stopping the Engine
1. Bring the machine to a full stop.
2. Move the motion control levers to the center
T-slot (neutral operate position).
3. Disengage the blade control switch.
4. Engage the parking brake.
• For E- and S-Series Models, move the control
levers outward from the center into the
T-slots.
• For X-Series Models, pull the lever up and
rearward.
5. Place the throttle in the "FAST" position.
6. Allow the engine to run for a minimum of 15
seconds, then turn the ignition switch to the
"OFF" position to stop the engine.
7. Remove the key to prevent children or other
unauthorized persons from starting engine.
g333874
25
Operation