Exmark QUEST S Series Operator's Manual page 19

Figure 6
X-Series Models
1. Park brake
The machine must be tied down and brake engaged
when transporting.
Deck Height Adjustment Hand
Lever—For 42 Inch E-Series Models
Note: 50 inch models have both deck height
adjustments: hand lever and foot assist pedal.
Located below the RH motion control lever.
Pull the lever inward and rearward to raise the cutting
deck. Allow the handle to move forward to lower the
cutting deck. Move the deck height adjustment lever
outward at the desired height of cut. Only adjust the
height of cut while the machine is not moving.
1. Deck height adjustment hand lever
g402796
Deck Height Adjustment Foot Pedal—
For 48, 50, and 54 Inch Models
Note: 50 inch models have both deck height
adjustments: hand lever and foot assist pedal.
Locate at the right front corner of the floor pan
(reference Figure 3).
The deck height adjustment foot pedal allows the
operator to use their leg to assist in lowering and
raising the deck from the seated position. Push the
pedal forward with your foot to raise the cutting
deck. Allow the pedal to move rearward to lower the
cutting deck to the cut height that has been set.
Fuel Window
Located on the left side of the machine (see Figure 8).
The fuel window can be used to determine the
amount of fuel in the tank.
19
Operation
Figure 7
g333845