Configuring a Clarity
Matrix G3 LCD Video
Wall
Video Wall Settings
Most video wall setup will be done through the Planar WallDirector software (see the
WallDirector, RPS and Video Controller User Interface Guide), however, the OSD has
much of the functionality required to do basic setup of displays and source routing.
Additionally, the system is capable of serial communication over multiple
connections within either the RPS or VCs.
Serial Communication
Control and status requests may be performed by other equipment such as a PC or
standard controller module. The system has three main means for these systems to
connect and a comprehensive command set to perform automated and user
actuated tasks. Refer to the RPS and Video Controller RS232 User Guide for information
on the types of connections and commands that may be used for the system.
Basic Image Software Configuration Steps
Configure the displays by performing steps in the following order:
1
2
Clarity Matrix G3 LCD Video Wall System Installation Guide
020-1339-00H
Matrix Layout - see "Matrix Layout Menu" on page 117.
Color Balance the displays - see "Adjusting Color Balance" on page 119.
Configuring a Clarity Matrix G3 LCD Video Wall
Page | 114