Device Configuration - Omron CJ Series Connection Manual

5.2. Device Configuration

The hardware components to reproduce the connection procedure of this document are as
follows:
Personal computer
(CX-One, installed,
OS: Windows 7 )
USB cable
Manufacturer
OMRON CPU Unit
(Built-in EtherNet/IP port)
OMRON Power Supply Unit
OMRON Switching hub
OMRON CX-One
OMRON CX-Programmer
OMRON Network-Configurator
- Personal computer
(OS: Windows 7)
- USB cable
(USB 2.0 type B connector)
- LAN cable (STP (shielded,
twisted-pair) cable of Ethernet
category 5 or higher)
OMRON FZ5 Sensor Controller
OMRON Camera
OMRON Camera cable
OMRON Monitor (analog RGB monitor)
- USB connected mouse
Precautions for Correct Use
Update the CX-Programmer and Network Configurator to the versions specified in this
section or higher versions using the auto update function.
If a version not specified in this section is used, the procedures described in Section 7 and
subsequent sections may not be applicable. In that case, use the equivalent procedures
described in the CX-Programmer Operation Manual (Cat. No. W446) and Network
Configurator Online Help.
Additional Information
The system configuration in this document uses USB for the connection between the
personal computer and PLC. For information on how to install the USB driver, refer to A-5
Installing the USB Driver of the CJ-series CJ2 CPU Unit Hardware User's Manual (Cat. No.
W472).
5．Applicable Devices and Device Configuration
CJ2M-CPU32
(Built-in EtherNet/IP port)
Switching hub
W4S1-05C
Name
CJ2M-CPU32
CJ1W-PA202
W4S1-05C
CXONE-AL[][]C-V4
/ AL[][]D-V4
(Included in CX-One)
(Included in CX-One)
-
-
-
FZ5-L350
FZ-SC2M
FZ-VS
FZ-M08
-
FZ5-L350
USB connected mouse
LAN
cable
FZ-VS
FZ-SC2M
Model
FZ-M08
Version
Ver.2.0
(Ver.2.12)
Ver.1.00
Ver.4.[][]
Ver.9.50
Ver.3.56
Ver.5.12
6