System Configuration - Omron SYSMAC CV500-BSC11 Operation Manual

System Configuration

Network Communications
Caution
!
1-2 System Configuration
Models
RS-232C (two) and
RS-422 Interfaces
CV500-BSC11
(without EEPROM)
CV500-BSC21
(with EEPROM)
Peripheral Devices
The other CPU Bus Units are the SYSMAC LINK Unit, SYSMAC NET Link Unit,
and SYSMAC BUS/2 Remote I/O Master Unit.
PC READ and PC WRITE can be used to transfer data to/from other PCs on the
same or interconnected networks; PRINT and INPUT, to transfer data to/from
BASIC Units on other PCs on the same or interconnected networks. The BASIC
Unit also supports automatic processing for certain FINS commands trans-
mitted via PC networks.
The BASIC Unit is equipped with a hardware test program that is used for in-
spection and maintenance. When this program is executed, the entire program
area will be initialized. This program is not intended for customer use. Do not set
the unit number to 99, turn ON pin 2 of the front-panel DIP switch, and restart the
BASIC Unit or turn power on.
Models with three different sets of interfaces are available, each of which is
available with or without EEPROM, making a total of six models of BASIC Units.
The appearance of these is shown below.
RS-232C (two) and
Centronics Interfaces
CV500-BSC31
(without EEPROM)
CV500-BSC41
(with EEPROM)
The following peripheral devices can be connected to the BASIC Unit. Note that
the peripheral device model that can be connected to the BASIC Unit depends
on the BASIC Unit Model.
Section 1-2
RS-232C (one) and
GP-IB Interfaces
CV500-BSC51
(without EEPROM)
CV500-BSC61
(with EEPROM)
3