Device Configuration - Omron CJ2H-CPU6*-EIP Series Connection Manual

5.2. Device Configuration

The hardware components to reproduce the connection procedure of this document are as
follows:
Personal computer
(CX-One installed)
OS: Windows 7
USB cable
Manufacturer
OMRON CPU Unit
(Built-in EtherNet/IP port)
OMRON Power Supply Unit
OMRON Switching Hub
OMRON CX-One
OMRON CX-Programmer
OMRON Network Configurator
- Personal computer
(OS: Windows 7)
- USB cable
OMRON Ethernet cable (with industrial
Ethernet connector)
OMRON Displacement Sensor
Controller
OMRON Displacement Sensor
Sensor Head
Calibration ROM
OMRON
Recommended power supply:
OMRON
24VDC 2.5A 60W
Precautions for Correct Use
Update the CX-Programmer and Network Configurator to the versions specified in this
section or higher versions using the auto update function.
If a version not specified in this section is used, the procedures described in Section 6 and
subsequent sections may not be applicable. In that case, use the equivalent procedures
described in the CX-Programmer Operation Manual (Cat. No. W446) and Network
Configurator Online Help.
5. Applicable Devices and Support Software
CJ2M-CPU32
(Built-in EtherNet/IP port)
Switching Hub
(W4S1-05C)
Ethernet
cable
Calibration ROM
Name
CJ2M-CPU32
(with built-in CJ2M-EIP21)
CJ1W-PA202
W4S1-05C
CXONE-AL[][]C-V4
/AL[][]D-V4
(Included in CX-One.)
(Included in CX-One.)
-
-
XS5W-T421-[]M[]-K
ZW-CE10
ZW-S40
(Included with Sensor
Head.)
S8VS-06024
ZW-CE10
Model Version
Ver.2.0
(Ver.2.1)
Ver.1.0
Ver.4.[][]
Ver.9.41
Ver.3.55
Ver.1.110
ZW-S40
7