Bop (Option); Buttons And Their Functions - Siemens SINAMICS G110 Operating Instructions Manual

5 BOP (Option)

5 BOP (Option)
5.1

Buttons and their Functions

Panel/ Function
Button
Indicates
Status
Start
converter
Stop
converter
Change
direction
Jog motor
Functions
Access
parameters
Increase
value
Decrease
value
12
Effects
The LCD displays the settings currently used by the converter.
Pressing the button starts the converter. This button is disabled by default.
Activate the button: P0700 = 1 or P0719 = 10 ... 15
OFF1 Pressing the button causes the motor to come to a standstill at the
selected ramp down rate. This button is disabled by default.
Activate the button: P0700 = 1 or P0719 = 10 ... 15
OFF2 Pressing the button twice (or once long) causes the motor to coast
to a standstill.
This function is always enabled.
Press this button to change the direction of rotation of the motor. Reverse is
indicated by a minus (-) sign or a flashing decimal point. Disabled by default.
Activate the button: P0700 = 1 or P0719 = 10 ... 15.
In the " Power-on/Ready" state, when this key is pressed, the motor starts
and rotates with the pre-set jog frequency. The motor stops when the button
is released. Pressing this button when the motor is running has no effect.
This button can be used to view additional information.
It works by pressing and holding the button. It shows the following, starting
from any parameter during operation:
1. DC link voltage (indicated by d – units V)
2. output frequency (Hz)
3. output voltage (indicated by o – units V).
4. The value selected in P0005 (If P0005 is set to show any of the above
(1 - 3) then this will not be shown again).
Additional presses will toggle around the above displays.
Jump Function
From any parameter (rxxxx or Pxxxx) a short press of the Fn button will
immediately jump to r0000, you can then change another parameter, if
required. Upon returning to r0000, pressing the Fn button will return you to
your starting point.
Acknowledgement
If alarm and fault messages are present, then these can be acknowledged by
pressing key Fn.
Pressing this button allows access to the parameters.
Pressing this button increases the displayed value.
Pressing this button decreases the displayed value.
Issue 11/04
SINAMICS G110
Operating Instructions (Compact)