List Of General Commands - Multitech ISI5634UPCI/4 Command Reference Manual

List of General Commands

Command Description
AT Attention Code
A Answer
A/ Repeat Last Command
B Communication Standard Setting – Bell or CCITT
D Dial
%M Enable Dialing Message
DS=n Dial Stored Telephone Number
E Echo Command
F Echo Online Data Characters
H Disconnect (Hang Up)
I Information Request
L Not Applicable
M Monitor Speaker Mode
N Modulation Handshake
O Return to Online Data Mode
P Set Pulse Dial Default
Q Result Codes Enable/Disable
Sr=n Set Register Value
Sr? Read Register Value
T Set Tone Dial Default
V Result Code Format
W Result Code Options
X Result Code Selection
Z Modem Reset
&C Data Carrier Detect (DCD) Control
&D Data Terminal Ready (DTR) Control
&E XON/OFF Pacing Control
&F Restore Factory Settings (Configuration)
&G Select Guard Tone Control
&K Flow Control Selection
&L Leased-Line Operation
&Q Asynchronous Communication Mode (same as \N Error Correction Mode)
&S Data Set Ready (DSR) Control
&T Loopback Tests
&V Display Current Settings (Configuration and Stored Profiles)
&W Store Current Settings (Configuration and Stored Profiles)
&Zn=x Store Dialing Command
\A Select Maximum MNP Block Size
\B Transmit Break to Remote
\K Break Control
\N Error Correction Mode Selection
\Q Flow Control Selection
\T Inactivity Timer
\V Protocol Result Code
-C Data Calling Tone
%A Adaptive Answer Result Code Enable
%B View Numbers in Blacklist
%C Data Compression Enable/Disable
%DC AT Command Control
%DT "AT" Command Timer
%E Fallback and Fall Forward Control
%H Direct Connect Enable
%R Cisco Configuration
%S Response Speed
$D DTR Dialing
$EB Asynchronous Word Length
$LB Long Break
$RP Response Priority
$SB Serial Port Baud Rate
Multi-Tech Systems, Inc. AT Commands for the MT5634 Family of Products (S000272H)
Chapter 1 – AT Commands
5