Escape Sequence Commands - Multitech ISI5634UPCI/4 Command Reference Manual

Command: #CBSn Callback Enable/Disable
Values: n = 0, 1, 2, or 3
Default: 0
Description: #CBS0
#CBS1
#CBS2
#CBS3
#CBS4
Command: #Pn Set 11-bit Parity
Values: n = 0 or 1
Default: 2
Description: #P0
#P1
#P2
Command: #Sx Enter Setup Password
Values: x= password (1–8 characters, case sensitive)
Default: MTSMODEM
Description: Enters the callback security setup password.
Command: #S=x Store Setup Password
Values: x= password (1–8 characters, case sensitive)
Default: MTSMODEM
Description: Stores a new callback security and remote configuration setup password.

Escape Sequence Commands

Command: Escape Sequence+++AT<CR> Escape Sequence
Values:
Description:
Command: Escape Configuration for Remote Configuration%%%ATMTSMODEM<CR>
Values:
Description:
Multi-Tech Systems, Inc. AT Commands for the MT5634 Family of Products (S000272H)
Disables callback security.
Enables local and remote callback security.
Enables remote callback security only.
Disables callback security until local hangup or reset.
Enables a callback security modem to originate a call without a connection
password prompt.
No parity.
Odd parity.
Even parity.
n/a
Puts the modem in command mode (and optionally issues a command) while
remaining online. Type +++AT and up to six command characters, then press ENTER.
Used mostly to issue the hang-up command: +++ATH<CR>.
Remote Configuration Escape Sequence
n/a
Initiates remote configuration mode while online with remote modem. The remote
configuration escape character (%) is defined in register S9.
Chapter 1 – AT Commands
23