Multitech ISI5634UPCI/4 Command Reference Manual page 13

Command: &Zn=x Storing a Dialing Command
Values: n = 0–3. Callback security disabled. 0, 1 used by MultiModemZPX/ZLI.
x = Stored telephone number
Default: None
Description: Stores dialing command x in memory. Dial the stored number using the command ATDS=n.
See also the #CBSn command.
Command: \An Select Maximum MNP Block Size
Values: n = 0, 1, 2, or 3
Default: 3
Description: \A0
\A1
\A2
\A3
Command: \Bn Transmit Break
Values: n = 0–9 in 100 ms units
Default: 3
Description: In non-error-correction mode only, sends a break signal of the specified length to a remote
modem. Works in conjunction with the \K command.
Command: \Kn Break Control
Values: n = 0–5
Default: 5
Description: Controls the modem's response to a break received from the computer, the remote modem,
or the \B commnd. The response is different for each.
Data mode. Modem receives the break from the computer:
\K0
\K1
\K2
\K3
\K4
\K5
Data mode. Modem receives the break from the remote modem:
\K0
\K1
\K2
\K3
\K4
\K5
Online command mode. Modem receives a \Bn command from the computer:
\K0
\K1
\K2
\K3
\K4
\K5
Command: \Nn Error Correction Mode Selection
Values: n = 0–5, or 7
Default: 3
Description: \N0
\N1
\N2
\N3
\N4
\N5
\N7
Multi-Tech Systems, Inc. AT Commands for the MT5634 Family of Products (S000272H)
0, 1, 2 used by MultiModemZBA.
0–29. Callback security enabled.
64-character maximum.
128-character maximum.
192-character maximum.
256-character maximum.
Enters online command mode, no break sent to the remote modem.
Clears data buffers and send break to the remote modem.
Same as \K0.
Sends break immediately to the remote modem .
Same as \K0.
Sends break to the remote modem in sequence with the transmitted data.
Clears data buffers and sends break to the computer.
Same as \K0.
Sends break immediately to the computer.
Same as \K2.
Sends break to the computer in sequence with the received data.
Same as \K4.
Clears data buffers and sends break to the remote modem.
Same as \K0.
Sends break immediately to the remote modem.
Same as \K2.
Sends break to the remote modem in sequence with the transmitted data.
Same as \K4.
Non-error correction mode with data buffering (same as &Q6).
For compatibility. Operates the same as \N0.
MNP reliable mode. If modem cannot make MNP connection, it disconnects.
V.42/MNP auto-reliable mode. The modem attempts first to connect in V.42 error
correction mode, then in MNP mode, and finally in non-error-correction (buffer)
mode with continued operation.
V.42 reliable mode.If the modem cannot make a V.42 connection, it disconnects.
V.42, MNP, or non-error correction (same as \N3).
V.42, MNP, or non-error correction (same as \N3).
Chapter 1 – AT Commands
13