Cornelius PRO ED FAST GATE Training Manual page 16

Pro ED Fast Gate Training Manual
Power cord must be
disconnected during this test.
1 A. Additional 24 Volt Circuit Tests —
Remove front panel cover.
NOTE: The magnetic proximity switch on
the ice chute must be closed (satis-
fied).
1 B. Manual Override Solenoid
Test —
Use an ohm meter to check pins 3
& 6,
there should be 93 ohms.
1 C. Pneumatic Gate Solenoid Test —
Use an ohm meter to check pins 5 & 6,
there should be 79 ohms.
- 12 -
1B.
Manual override
solenoid
White/
3 1
Orange
6 4
Red
Black
9 7
1C.
Portion
control
panel
connector
White
Blue
wire
wire
© 2003 IMI Cornelius Inc.
Pneumatic gate
solenoid
Low voltage
connector
layout