Powering Up - Multitech MA6 Quick Start Manual

Powering Up

Note: This is plugable equipment; the socket outlet must be installed near the equipment and
must be easily accessible.
Make sure that the voltage selector on the power supply is set to the proper voltage prior to
connecting this equipment to the main power. If the voltage selector needs to be changed,
an ordinary pencil can be used to change the switch to the position which best correlates with
the known input voltage. If the voltage selector is in the "115" position, input voltages from
100-120VAC may be applied to the equipment. If the voltage selector is in the "230" position,
input voltages from 200-240 VAC may be applied to the equipment.
Connect the power cord supplied with the MiniArray
back of the cabinet and to an AC outlet. Press the power switch on the front of the cabinet to
the ON position. The power switch contains an LED which should light when power is
applied.
16
Fig. 2-5. Power Supply Connectors
III
to the power cord connector on the
•
[( )]
MA6