Table of Contents
Advertisement
Safety Warnings Telecom
1.
Never install telephone wiring during a lighting storm.
2.
Never install telephone jacks in wet locations unless the jack is specifically designed
for wet locations.
3.
This product is to be used with UL and cUL listed computers.
4.
Never touch uninsulated telephone wires or terminals unless the telephone line has
been disconnected at the network interface.
5.
Use caution when installing or modifying telephone lines.
6.
Avoid using a telephone (other than a cordless type) during an electrical storm.
There may be a remote risk of electrical shock from lightning.
7.
Do not use the telephone to report a gas leak in the vicinity of the leak.
8.
To reduce the risk of fire, use only No. 26 AWG or larger Telecommunication line
Cord.
Rack Mounting
The MiniArray
enclosure mounting screws are provided in your MiniArray
the unit securely to the rack enclosure.
In order to maintain proper operating temperatures, there is a one-inch clearance requirement for
Cable Connections
The cabling required for the MiniArray
or in the case of integrated multiport ISI/Modem, plugging the RJ11 cables into the multiport
ISI/Modem modular receptacles; and a NIC connection to the network. The SBC board has
cable connectors for adding a monitor and keyboard. Cable connectors and boards are
shown in Figure 2-1.
MA6
In order to prevent injury or damage to the unit, it is recommended that
two people mount the MiniArray
III
is designed to mount in a standard 19-inch rack enclosure. Four (4) rack
the back of the unit. If mounted in a rack enclosure or as a desktop unit, there
must be a minimum of one inch between the back of the MiniArray
any wall or barrier, and the front of the MiniArray
Caution
III
in the rack enclosure
III
kit. Use these screws to mount
Note
and any wall or barrier.
III
involves connecting the ISI board(s) to the modems;
III
and
III
13
Advertisement
Table of Contents
