Table of Contents
Advertisement
5
Disconnect the power and data cables from the back of the floppy disk drive.
6
Remove the four screws securing the floppy drive to the drive chassis.
7
Open the front door, remove floppy drive by sliding it out the front of the drive
chassis.
8
To install a new floppy drive, follow steps 1-7 in reverse.
CDROM Removal/Replacement
Step
Procedure
1
Remove the MiniArray
2
Remove the top cover from the MiniArray
screws located in the back of the MiniArray
3
Remove the chassis mounting screw from the card cage. See figure 4-4.
4
Being careful to maintain slack in the power cables, lift the card cage, including fan
housing, up and over so that it can rest along side the chassis.
5
Disconnect the power and data cables from the back of the CDROM drive.
6
Remove the four screws securing the CDROM drive to the drive chassis.
7
Open the front door and remove CDROM drive by sliding it out the front of the drive
chassis.
8
To install a new CDROM drive, follow steps 1-7 in reverse.
Power Supply Removal/Replacement
The card cage has to be removed in order to disconnect the power wiring before the power
supply can be removed.
Step
Procedure
1
Remove the MiniArray
30
Before installing card cage, make sure power connectors from
power supply to midplane are fully connected.
Table 4.6 CD ROM Removal/Replacement Procedure
III
from rack enclosure following the steps in Table 4.1.
Before installing card cage, make sure power connectors
from power supply to midplane are fully connected.
Table 4.7 Power Supply Removal/Replacement Procedure
III
from rack enclosure following the steps in Table 4.1.
Note
III
by removing the seven cover mounting
III
. See figure 4-3.
Note
MA6
Advertisement
Table of Contents
