Table of Contents
Advertisement
The SX16+ Relay Controllers can easily
communicate with virtually any computer equipped
with a serial communications port (RS-232C).
Knowledge of BASIC or other programming
language will allow direct control, programming and
status of the SX16+ via a computer terminal. The
computer I/O lines are detailed on Page 30 of this
manual. Consult AMX for information on software
available for control of the SX16+.
Setting Baud Rate
Various Baud rates may be set for an SX System
that is interfaced to a computer or to a telephone
line via a modem. The normal configuration is 8
data bits, 1 stop bit and no parity.
Baud rate setting is a 'global' command that sets all
SX16+s in a system to the same rate. The last
setting made (on any SX16+ in the system) is the
one stored until the next change.
To Set Baud Rate
Press Buttons 15, 16 and 10 Simultaneously
AMX Reserves the right to alter specifications without notice at any time.
040-004-1072 7/88
AMX Corporation, 3000 Research Dr. Richardson, TX 75082
Connecting Computer Terminals to SX16+ System
After pressing these buttons an LED will light in one
of the first 6 buttons on the SX16+.
The buttons correspond to the following Baud
Rates:
#1 - 300
#2 - 600
#3 - 1200
#4 - 2400
#5 - 4800
#6 - 9600
All SX16+ Relay Controllers are shipped with the
1200 Baud rate pre-set.
If Changes are desired -
Exit With Changes
Press Buttons 15, 16 and 13 Simultaneously
If just checking Status -
Exit Without Changes
Press Buttons 15, 16 and 14 Simultaneously
12
Page
800.222.0193
Advertisement
Table of Contents
