Table of Contents
Advertisement
Installation
Installation
Inside the NXP-PLV
The NXP-PLV combines AMX touchpanel sensitivity and versatility with industry-standard joystick
controls. FIG. 15 shows the unpowered device as it appears before installation.
Speed
Iris
Focus
FIG. 15
NXP-PLV removed from packaging
Unpacking the NXP-PLV
1. Inspect and confirm the contents of the shipment box to verify you have all specified parts.
2. Carefully remove the device from the shipping box.
3. Carefully peel the protective plastic cover from the LCD touchscreen.
If the protective plastic LCD cover is not removed, the device may not respond
properly to touch points on the screen or allow proper screen calibration.
Connecting the NXP-PLV
The NXP-PLV is intended to stand alone on a desktop or tabletop without a bracket or support platform,
but it still needs to communicate with its associated cameras in order to function. This may be done by
connecting it to a NetLinx master or via a hub or router, but the device still needs to be powered up and
connected before it is fully functional.
1. Make sure that all data and power wiring connectors are connected to their respective terminal
locations on either the Breakout Box, Ethernet port, or NetLinx Master.
2. Connect all data and power wiring connectors to their corresponding locations along the back of the
(un-powered) PosiTrack Pilot. Verify that the terminal end of the power cable is not connected to the
a power supply before plugging in the 2-pin power connector.
3. Test the incoming wiring by connecting the device connections to their terminal locations and
applying power.
4. Connect the terminal power connector on the 12 VDC-compliant power supply and apply power.
13
NXP-PLV Modero PosiTrack Pilot Camera Controller
Joystick
Advertisement
Table of Contents
