ETX - STX 150
Electrical system installation
INTRODUCTION
Scope and applicability
This document aims at defining the cable harness routing in order to achieve the vehicle reliability
targets.
CHASSIS
Materials used and corresponding quantities
The electrical system consists of the following cable harnesses and parts:
•
1 Battery
•
1 Vehicle cable harness
•
1 Positive battery cable
•
1 Battery - engine ground cable
•
1 Right handlebar control
•
1 Left handlebar control
•
1 Horn
•
1 Ignition switch
•
1 Instrument panel
•
1 Lights control unit
•
1 CDI
•
1 Diode
•
1 Headlamp
•
1 Taillight
•
1 Right front turn indicator
•
1 Left front turn indicator
•
1 Rear right turn indicator
•
1 Rear left turn indicator
•
1 Front stop switch
•
1 Clutch switch
•
1 Rear stop switch
•
1 Voltage regulator
•
1 Start-up relay
•
1 Fuel level sensor
•
1 Speed sensor
ENGINE
Materials used and corresponding quantities
The electrical system consists of the following components:
Electrical system
ELE SYS - 41