Finishing A Test; Performing Successive Tests; Working With Patient Test Results; Viewing Patient Test Results - Siemens Healthineers Atellica VTLi User Manual

Close the analyzer cover after each use to protect it from dust and other foreign particles
and substances.
Finishing a test (Finish screen)
INSTRUCTIONS
1. Tap Finish.
The analyzer displays a confirmation message.
2. Do one of the following:
‒ Tap Accept to accept the results and finish testing. Results can be accepted when no
errors occurred during handling or testing.
‒ Press Reject to reject the set of tests. Results should be rejected when a handling or user
error has occurred during testing and the results cannot be trusted.
‒ Press Cancel to return to the previous screen.
The analyzer does not interpret test results. Accepting or rejecting test results does not
qualify or disqualify the measurement.
The analyzer displays "Remove cartridge."
10:12 30-03-2020
Result Review
Showing filtered results
Today 30-03-2020
POS
10:12 AM HighSe...
ID Anonymous
80.89
10:12 AM HighSe...
ID Anonymous
PASS
10:12 AM HighSe...
ID Anonymous
8:15 TROP-I
0.009
QC Lot liquidLotId
Yesterday 29-03-2020
Filter
3. Remove the cartridge.
If the analyzer is docked and a LAN is connected to the docking station, the results are
transferred via the LAN connection. If the docking station is not connected to a LAN,
the results are transferred via WiFi if it is enabled. If the analyzer is undocked, and WiFi
is enabled, the results are transferred via WiFi.
Performing successive tests (Results screen)
Some tests support testing consecutive samples for the same patient.
INSTRUCTIONS
1. Follow the procedures described in the previous sections for performing a test.
2. Do one of the following:
‒ Tap Next to perform additional tests.
‒ Tap Finish when all tests are completed.

Working with Patient Test Results

Viewing patient test results

INSTRUCTIONS
1. Tap > Results Review.
2. Do one of the following:
Chapter 2 - Testing Patient Samples
23