Connecting The Docking Station; Installing The Analyzer Battery - Siemens Healthineers Atellica VTLi User Manual

Chapter 1 - Exploring the Atellica VTLi Immunoassay Analyzer

Connecting the docking station

INSTRUCTIONS
1. Connect one end of the Ethernet cable to the docking station, and the other end either
to a port on the local network or directly to the PC.
2. Connect the AC power adapter to the docking station and connect the AC power adapter
to the power source using the power cord.
The docking station should be connected to the AC power source so that it can charge
the analyzer battery and cool the analyzer with the cooling fan. If the docking station is
not connected to the power supply with the analyzer docked, the analyzer battery
will drain.

Installing the analyzer battery

Before you can use the analyzer, you need to install the battery using the torx screwdriver
included in the accessories box.
Prior to use, you must charge the analyzer battery for at least one hour to ensure that
the analyzer can function correctly when it is used undocked. A partial battery charge
takes one hour; a full battery charge takes approximately 2 hours.
When undocked, the system is capable of performing at least one test after one hour
of battery charging, but it is preferable to fully charge the battery before using for the
first time
INSTRUCTIONS
1. On the back of the analyzer, locate the small screw holding the battery cover in place.
2. Use the torx screwdriver to remove the screw completely and set it aside.
3. Slide the cover upward to remove it from the analyzer.
4. Insert the battery plastic wire connector into the analyzer. You should hear or feel it
snap into place.
5. Fit the new battery into the battery compartment.
6. Position the wires before reattaching the cover.
Ensure that the wires are not crimped and will not interfere with reattaching the
battery cover.
7. Slide the battery cover back into place on the analyzer.
8. Reinsert and gently tighten the battery cover screw.
8