Periodic maintenance and adjustment
Release the " /LOCK" section of
the center switch after the smart
key system indicator light flashes
once.
↓
The first digit of the identification
number has been set as "1".
↓
Push and hold the " /LOCK"
section of the center switch again.
↓
Release the " /LOCK" section of
the center switch after the smart
9
key system indicator light flashes
twice.
↓
The second digit has been set as
"2".
↓
Repeat the above procedure until
all digits of the identification num-
ber have been set. The smart key
system indicator light will flash for
10 seconds if the correct identifi-
cation number was entered.
TIP
Emergency mode will be terminated
when either one of the following situa-
tions apply. In this case, start over
again from step 2.
When there are no " /LOCK"
section of the center switch oper-
ations for 10 seconds during the
identification number input pro-
cess.
When the smart key system indi-
cator light is allowed to flash nine
or more times.
5. Press the " /LOCK" section of
the center switch while the smart
key system indicator light is on to
turn on the power to the vehicle.
The engine can now be started.
TIP
If the identification number is not
correctly entered, the smart key
system indicator light will flash
9-40
rapidly for 3 seconds and emer-
gency mode is terminated. In this
case, start over again from step 2.
To lock the handlebar after turning
on the vehicle in emergency
mode, turn the vehicle power off,
and then turn the handlebar to the
left and press the " /LOCK" sec-
tion of the center switch.