Alarm Codes & Led Code Chart - Intex Krystal Clean Poolwater 8221 Owner's Manual

Alarm Codes & LED Code Chart
Alarm Codes
No chlorine production will occur if "Low Water Flow", "Low Salt Level" or "High Salt Level" are detected.
If any of these conditions occur then the Saltwater System will sound an alarm that indicates chlorine
production has stopped. A buzzer will sound and a Code (see below) will keep flashing on the LED
for 1 hour. The buzzer and flashing light will end after one hour and the Saltwater System will go to
Power Saving Mode. If this occurs then press any button (
problem so that it can be corrected.
Turn off the power of the unit and follow the solutions below to solve the problem. Turn on the unit again
by following the "Operating Instructions".
Code Cause
1. Circulation line blocked.
Low Water
Flow or
No Flow
2. Incorrect inlet and
outlet hose direction.
3. Scale on the flow sensor.
4. Flow sensor cord is loose. • Check for flow sensor loose or not connected
5. Flow sensor failure.
1. Dirt or scale on titanium
plates.
Low Salt 2. Low salt level.
Level 3. Possible electrolytic cell
failure.
1. High salt level.
High Salt 2. Possible electrolytic cell
Level failure.
SAVE THESE INSTRUCTIONS
(104) ENGLISH SALTWATER SYSTEM/FILTER PUMP MODEL8221/8231 SIZE: 7.5" X 10.5" 09/18/2006
Remedy
• Ensure the plunger valves are opened (if any).
• Ensure your filter cartridge, cell and debris
screen are clear from debris and dirt.
See "Maintenance".
• Release all trapped air in the circulation line.
See Filter Pump Manual.
• Check for the direction of water inlet and water
outlet hose. Reverse the hoses if necessary.
See "Set Up Instructions".
• Ensure the flow sensor (especially the hinge)
is clean. See "Maintenance".
properly. Plug the flow sensor firmly into the
flow sensor receptacle.
• Contact Intex Service Center for replacement.
• Remove the electrolytic cell for inspection and
clean it if necessary. See "Maintenance".
• Add salt. See "Salt & Pool Water Volumes".
• Contact Intex Service Center. Replace the cell
if needed.
• Partially drain the pool and refill with fresh water.
See "Salt & Pool Water Volumes".
• Contact Intex Service Center. Replace the cell
if needed.
Page 16
or ) to view the code of the original
104
Flashing Buzzer
Yes Yes
Yes Yes
Yes Yes